Isogen for CADWorx - (TIFC1001)

Hoofddorp, Netherlands - Hexagon PPM Offices
14 May, 09:30 AM - 14 May, 05:00 PM

This administrator level course is for project administrators or anyone responsible for setting-up and configuring Isogen to produce piping isometric deliverables as part of a CADWorx project who want to learn how to configure Isogen drawing and report outputs to optimize them in accordance with their company standards and project requirements. Attendees from this course must have familiarity with the AutoCAD user interface and commands and understanding of how isometrics are generated from CADWorx models.

Course Content: 

  • Introduction to I-Configure
  • Introduction to Isogen Configuration
  • Isogen capabilities in CADWorx
  • Attributes
  • Alternative Text
  • User Fonts
  • Dynamic File Naming
  • Material List
  • Material Group Transfers
  • Cut List
  • Detail Sketches and Notes
  • Custom Symbols
  • Welds and Cut-Piece Add-On Allowances
  • Curved Pipe
  • Mitred Pipe
  • Existing Components
  • Isogen Splitting
  • ISOGENOUT vs. ISOGENBATCH
  • Continuation Graphics
  • Reference Dimensions
  • Repeatability
  • Isogen Supplemental
  • Supports and Reinforcing Pads/Saddles
  • TAP and OTAP
  • Isogen Settings
  • Isogen error messages in CADWorx
  • PCF Commands
  • Pre and Post-Processors
  • Project and Style Backup
  • Advanced Isogen Configuration exercise
  • Upgrading from PipMan v2 to I-Configure (optional)
  • Creating a user-defined style template
Please note the cost of this course is 550 EUR.